Despite all the above, the output is clean, crisp, and dry. Fuse system Number of yellow images 4, prints Y toner low 6, prints Y toner empty M toner New unit detection: After that, you must contact the OEM company directly. Push on the right pin section and, while carefully bending the front cover, remove it to the right. Toner controller plate This evenly applies the toner to the developing roller. Does the error reoccur?

Uploader: Gajora
Date Added: 18 October 2015
File Size: 19.56 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 66640
Price: Free* [*Free Regsitration Required]

Our premium toner cartridges are the perfect replacements to their OEM versions. Paper exit sensor PC 8 Detects that the paper has been discharged. LD3 Sensor input confirmation Checking sensor input is done in test mode.

konica, minolta, magicolor, 2200, toner, cartridges, minolta, qms, 2200, toner

Remove the 8 set screws for the controller box. If this product uses a laser, laser beam leakage may cause eye damage or blindness. Defective paper image transport. Until we can be sure to deliver the same level of customer satisfaction we can ensure in the USA, we’d rather not accept your order than risk letting you down.

Does the engine cooling fan oper- ate? Pressure roller N Fusing roller Fusing roller Suction fan Paper Exhaust flow C Fusing section Fusing unit Fusing the toner to the media is accomplished by a belt heat fusing system. Paper exit roller for each bin 4. No Check magicolod in multipurpose tray to ensure it is not overloaded.


Technical Details

Remove the control panel cover. Image Defects that are Cyclical mm spacing. Minolta is a trade- mark of Minolta Co. Konica Minolta magicolor Color Laser Printer.

Minolta-QMS Magicolor DeskLaser Overview – CNET

Warm-up completed Initialization completed B C. Remove 5 screws from the transport motor driving assembly. Does heater lamp 1 H2 come on when the power supply is turned on?

When you print a mixed stack of portrait and landscape sheets together, the 220 mode sheets will come out in the reverse direction – meaning the right side of the sheet will come out of the printer last – this means you have to manually sort thru an entire stack and rotate each landscape sheet degrees to get it into it’s “correct” orientation. Remove the paper take-up section cover 1.

Full text of “Konica Minolta QMS magicolor Service Manual”

Image transfer roller The toner image on the image transfer belt is transferred to the paper. If the paper is longer or shorter than the specified length, a paper size error is detected.

Power supply fan motor operation No.

Is it in stock? Half speed at the start of printing. Remove the developing motor assembly Spring 1. I didn’t get qm see the before I purchased it but now that I own one I can make the q,s between all three. Impurities in the OPC drum.


Once the paper has been discharged to the specified position, the switch back motor operates in reverse to send the paper to the duplex unit.

When discharging to bin 1.

Touching it could result in an electric shock or burn. Fusing roller Pressure roller Pressure roller release detecting sensor PC 14 Pressure 22200 using pressure position detecting sensor PC 10 C Paper exit section The static electricity on the fused paper is removed by the brushes as the paper is discharged to the paper exit tray 2 Name Function 1.

The 24 eraser lamps LED on the eraser board come on and remove the electrical load for the unexposed sections by magicoolor the surface of the OPC drum for the pre-image transfer of the image on the image transfer belt.

Paper exit sensor Failure to discover damage could result in electrical mqgicolor or fire. No Close the multipurpose paper take- up section and then open it.