Installing a wrong or unauthorized part could cause dielectric breakdown or overload, or undermine safety devices resulting in possible electric shock or fire. Bought this hoping to replace those expensive inkjet cartridges. Mon to Fri 8. Do not open the cover when the power is on. Yes Clean the timing roller. Remove the left frame plate. Remove the 5 screws for the upper-right reinforcement plate.

Uploader: Kagatilar
Date Added: 4 November 2006
File Size: 45.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 72643
Price: Free* [*Free Regsitration Required]


It has been mounted at the factory using a positioning jig to ensure that it is level. Letter A Size 8. I’m going to buy another one because it’s cheaper then fixing this one and Buying the four toner cartridges.

Print a consumable sta- tistics page. Remove the insulation sheet.


Yes Clean the reflector plate for the OHP. Toner cartridge rack error detection is detected when the black cartridge home position sensor PC6 is not set to on within 3 seconds after the rack motor M3 has started to operate during the initialization of the toner cartridge rack position.

Until we can be sure to deliver the same level of customer satisfaction we can ensure in the USA, we’d rather not accept your order than risk letting you down.

Qmd lines mm spacing. Clean the laser lens cover and paper take-up rollers by gently wiping the surface with a soft, dry lint-free cloth. Replace magicolog duplex unit. We are happy to:. Problem Check Result Corrective action When there is paper in the printer. Multipurpose tray position sensor PC 15 Detects the upper and lower position amount of the multi-pur- pose tray.


A-3 Installation space Always provide adequate space around the printer to ensure proper cooling and easy inspection and maintenance. Because the film is transparent, the LED light from the light-emitting section of the sensor passes through it and is reflected by the Prism Lens mounted at the top of the sensor. The image is then transferred on the image transfer belt.

When waste toner fills the waste toner container up to the waste toner full sen- sor section, it blocks the LED light from the sensor, and the toner full detection is made. Also, there is no way to have the driver save the options you select when printing from other programs like Word; you must just hit enter after your selections because there is only a “Restore defaults button. It has been mounted at the factory using a jig and the drive gears adjusted to ensure optimum gear meshing.

Konica Minolta 1710478-001 QMS Magicolor 2200 Transfer Belt

Clean the paper transport passage. The electric load remaining on the paper is removed when the removal bias that is supplied by HV2 is applied to the charge removal plate.

In very rare cases where the manufacturer itself is temporarily unable to keep up with demand, we may be subject to the same availability constraints as everyone else.


There were highly noticeable bands of different colors that sharply switched to other colors.

Use the specified jinolta. Sorry, we are temporarily out of this item. Does the toner suction fan motor Mil operate during power on initialization? Remove the 1 connector for the transport motor. No Turn power switch on. No Properly connect the power cord to the printer.

At up to 5 color pages or 20 black-and-white pages a minute, the DeskLaser can replace slower colour inkjet and monochrome printers. Service call messages When a service call message is displayed, the printer has a mechanical problem. These cartridges are designed to meet or in some cases even exceed the standards set by the OEM in terms of performance, print quality and page yield.

Precautions during cold weather opera- tion.

Electrode roller The toner image on the OPC drum is transferred to the image transfer belt. Remove the 5 screws for the upper-right reinforcement plate. An image transfer roller operation error is detected when there is no change in the output of the image transfer roller pressure mqs PC7 after the specified time has passed since the image transfer roller pressure solenoid SL7 was set to on.