LAN configuration config interface lan option type bridge option ifname “eth0. Remove the 4 nubs under the case, now you can see some screws. See thread for more information. The company receives excellent marks for their ease of setup and reliability. This way you can get

Uploader: Goltirisar
Date Added: 13 September 2012
File Size: 35.88 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 23382
Price: Free* [*Free Regsitration Required]

At right from these points, you can see printed pin descriptions V Flow control is off for TX and off for RX [ At right from these points, you can see printed pin descriptions V1: LAN and WiFi is bridged to br-lan.

ASUS WL-500gP V2 – wireless router – 802.11b/g – desktop Series

V90 cc 0x, rev 0x02, vendor 0x [ 0. User Tools Register Log In.

Quoted network speeds and bandwidth based on current IEEE Example configuration, every port “autonomous”. SPROM revision 2 detected.

ASUS WL-500g Premium

Installed on v2 via tftp, contrary to above claims that wireless will preimum work, wireless seems to be working fine.


Faster than previous versions but it consumes more RAM memory, more features available.

The default network configuration is: Problems Well xsus was lucky and i got no problems, if they appear, just report them here. The WLgP is supported by two targets: LAN ports are switch ports 1,2,3,4.

PCI cc 0x, rev 0x08, vendor 0x [ 0. Below are the device manuals available for your WLgP v2.

ASUS WLgP V2 – wireless router – b/g – desktop Overview – CNET

If the firmware restoration tool can’t seem find your router even though you are certain that it is in diag mode, it may be because the restoration tool is not very smart about which network interface to use.

Found chip with id 0x, rev 0x02 and package 0x02 [ 0.

In diag mode, the router takes the address stored in nvram, usually Starting program at 0x Linux version 2. Please refer specification pages for full details.

With the bundled AiDisk quick installation guide included in the box, users can rest easy and not worry about complicated settings. Looking for dual image [ 0. Analog 3, Type 2 GRevision 7 [ Flow control is off for TX and off for RX.

Related Drivers  HP DESKJET D1341 WINDOWS 7 DRIVER

WLgP V2 BIOS & FIRMWARE | Networking | ASUS Global

Sonics Silicon Backplane found at address 0x [ 0. This process usually works for resetting any router to it’s factory setting.

Fast Ethernet cc 0x, rev 0x06, vendor 0x [ 0. Saus of such mod can be found here on OpenWrt forum. Will extract v1 [ 0.

You should be able to telnet to your router IP address: Registered protocol family 16 [ 0. This applies to v1 models only! Tested with v1 models. The router will reboot itself automatically after the upgrade is complete.